Oyaide OR-800A Speaker Cable

Cotton yarn is also an insulator used in electric wire, is the most oldest category. Even now insulator, there is a high-tech material over a wide, but I dare to adopt the cotton yarn. In the design of cable, dielectric constant, conductor resistance, such as an electrostatic capacity and is raised there are a variety of factors in addition to. Among other things, vibration, we believe that an important issue with respect to static electricity. The cable will always be a potential difference occurs, but the potential difference is violently changed by the self-vibration, an external vibration during energization, and cause noise.Since the cotton itself does not vibrate, in terms of vibration damping compared to other compound material there is overwhelming superiority. If an electrical (signal) flows through the cable, causing electromagnetic induction, electromagnetic field variation is to magnetized electrostatic randomly on the surface of the insulator. Cotton yarn and natural materials is a cause of noise there is a feature that is not magnetized the static electricity, to prevent the disturbance of the potential difference due to static magnetic susceptibility.

ELEC electricity is also sticking to the terminal. In terms of sound If you thought the speaker cable as one of the components, it is the part that still can not be overlooked terminal. Without compromising the character with a cable, it was specially prepared the Y rug to actively tone control rather. 2mm than the plate of oxygen-free copper of thickness, multiplied by the silver plating of the thick after the punching surface smooth processing shape, further gave a consuming tasks pains that applying a palladium plating.

That make a good one, "that spare no pains," it is ELEC style. Sound image would make if no, it is ELEC style. For 6mm so that the shape is to adapt to any speaker, 8mm post corresponding OR-800 is the wire is using the Ritz lines are insulated, inevitably sound is to be shipped in a state where the processing terminal not. So, marinated in once a solder bath the wire as the terminal processing step, do the soldering the terminal to Y lug on alloyed.

Finally, the exterior covering the cable in order to suppress the dielectric constant, has adopted a polyolefin-based material.Compared to conventional plastic, and even more in the dielectric constant of the material itself is 1/3 or less, we have a tone control by exterior hardness.

Exterior uses only reinforced fiber sleeve to hate simple color ring of material, in order to prevent the charge of static electricity caused by friction, it has undergone a anti-static processing.

The conductor is, using the first kind OFC (oxygen-free copper wire), we use the four ultra-fine line of 7/57 / 0.12 (399 pcs).In the case of twisted multi-core of a thin line, and energy loss line between distortion occurs, it will be the cause of the noise caused by the electromagnetic field disturbance. In the case of Ritz line, line-to-line distortion is unlikely to occur because the one by one conductor very fine line there is each film (UEW), further, allows you to greatly suppressed and pure transmission degradation of the high-frequency characteristics due to the skin effect .

The internal structure of the cable, as the characteristics of the star quad structure this structure that continued to defend stubbornly to 20 years less susceptible to the influence of external noise, there is a feature that it is difficult to put out the noise. Since the electromotive force generated in good to electromagnetic induction of the magnetic flux is reversed in the next to each other, cancellation occurs. Therefore, the general shield (copper ed its, aluminum foil) external noise without increasing the capacitance using, such as electromagnetic wave shielding of, to prevent leakage.

RMA acquisition, lead-free (2.95% 0.5% copper silver) to the soldering of the solder used (non-chlorine-based flux containing) wiring, Pb pretend the RMA acquisition of the United States Federal standards - using solder. Tin - silver (2.95%) - copper often very balance tone in the composition of the (0.5%), there is no clouding of lead-specific lead-free. Rather than solder the sound quality is good, it is a solder which does not give an adverse effect on the last sound.