High precision cut by computer control the optimal high-rigidity material SUS303 stainless steel material to receive spike
SUS303 to be used in the "INS-SP" indicates excellent cord properties compared to other metals, is the perfect high-rigidity material to receive spike. And "INS-SP" is by a high-precision cutting of stainless steel by computer control, and equipped with a high dimensional accuracy and high rigidity, which are required to receive a spike. Accordingly, without causing backlash, deformation, and enables the contact perfect point of the spike.
Strength properties comparison of SUS303 and stainless steel to be used in the INS-SP, with other metals
Strongly to corrosion, such as rust, hairline finish shine in semi-gloss
SUS303 stainless steel used in the "INS-SP", because the strong passive film on the surface (film consisting of Cr and O) is formed, strongly corrosive, such as rust, can be long-term maintenance aesthetics. In addition, SUS303 stainless steel is a non-magnetic material, it does not have a any of the adverse effects of magnetic to your equipment. Then, the surface of the "INS-SP" is hairline finish shine in semi-gloss. While penetration without discomfort in your system, casually produce a chic luxury.
Ensure the depth of accurately inset can dent a spike
"INS-SP" is, 2mm the depth of the dent to fitting the spike, the diameter of the dent and 8.8mm, we are ensuring the visibility and fitted with the necessary and sufficient strength. This easy to dent and visibility at the time of installation, to make it easier fit the spike. Further, even when the impact from the lateral direction applied to the instrument, without the spike it deviates from dents and has a stable fitted resistance. In addition, the angle of the dent and 130 degrees, as well the sharp spike of 90 degrees or less, supports a wide range even at an obtuse angle of the spike of up to about 120 degrees.
Not only as a spike received, also available reversible design as a small-sized insulator
"INS-SP" is easy to handle in the coin size, not only as a spike received, is reversible specifications that can be used as a small-sized insulator. Small But that compromise in sound quality does not have any. By using the "INS-SP", while increasing the density impression, straight tone can be obtained in the tight of hard material unique.
In combination with INS-US, realizing the contact best match point
"INS-SP" is, to be able to exert the maximum effect by using a pair as "INS-US", it has been designed with a common design concept and the size. By using in pairs, to achieve the ideal point contact insulation.
"INS-US" and the height of when was fitting the "INS-SP" and: 13.9mm
"INS-SP" is, that can be fitted into a multi-base insulator "INS-BS", because it has been designed as a spike receptacle with a diameter of 20mm size, further sound quality Tune in combination with the "INS-BS" can be done. For example, when a combination of tone to "INS-SP" in whether to equipment side on the floor side of change. Including tuning by the 3-point support and 4-point support, you can enjoy a variety of settings.
Specification
Material: Stainless steel (SUS303)
Size: φ20, H 6.0, spike dent depth 2.0, spike dent angle 130 degrees
Mass: 14.7g / Pieces
Withstand load: 1 per 200kg
The number of packing: Set of 4
