Ortofon MC Quintet Red 唱頭

***本店商品網上及門市同步銷售，系統有機會未及時更新，將會有職員致電聯絡。***

***有現貨的商品1-3個工作天內會跟進及寄出。訂貨約需1-2個月。***

⬇️ MC Quintet 文件下載 ⬇️

用戶指南

產品資料

Features

Enter the Exclusive world of Ortofon’s famous moving coil sound!

The Quintet Red is a perfect introduction to the world of Ortofon moving coils.

It features an Elliptical diamond which is cut and polished to Ortofon’s standards.

This entry-level MC cartridge has very high price-to-performance ratio and is a perfect all-rounder for the newcomers to the world of Moving Coil cartridges.

MC Quintet Red is an all-purpose cartridge that delivers open, dynamic sound with a slight touch of warmth.

The ST-7 transformer is a perfect match for the MC Quintet Red cartridge.

LH-4000 headshell is specially recommended for MC Quintet cartridges series. 

MC Quintet Red Technical data

Output voltage at 1 kHz 5 cm/sec - 0.5 mV

Channel balance - < 1.5 dB

Channel separation at 1 kHz - > 21 dB

Channel separation at 15 kHz - > 14 dB

Frequency response 20-20.000 Hz - +/-2.5 dB

Tracking ability at 315 Hz at recommended tracking force *) - 65 μm

Compliance, dynamic, lateral - 15 μm/mN

Stylus type - Elliptical

Stylus tip radius - r/R 8/18 μm

Tracking force range - 2.1-2.5 g (21-25 mN)

Tracking force recommended - 2.3 g (23 mN)

Tracking angle - 20º

Internal impedance, DC resistance - 7 Ohm

Recommended load impedance - >20 Ohm

Cartridge body material - ABS/Aluminium

Coil wire material - Copper

Cartridge colour - Red

Cartridge weight - 9 g

*) Typical value

Compatibility with Rega brand TT/TA: 

REGA brand cartridges’ height from stylus tip to the top cartridge mounting surface is lower than standard. Therefore you would need spacers to ensure the correct set-up of the Ortofon cartridge.

Adjusting the height of your Rega tonearm is easy with Acoustic Signature's Spacer Set. It allows you to adjust the height from 0.5 mm to 3.5 mm in precise steps of 0.5 mm - without removing the tone arm. Simply loosen the screws, insert the AS-spacer, then lock the screws back down, and you're tonearm is ready to play.

3.2 - 4 mm spacers should be enough for Quintet cartridge.