Ortofon MC Quintet Mono 唱頭

***本店商品網上及門市同步銷售，系統有機會未及時更新，將會有職員致電聯絡。***

***有現貨的商品1-3個工作天內會跟進及寄出。訂貨約需1-2個月。***

⬇️ MC Quintet 文件下載 ⬇️

用戶指南

產品資料

Features

A True Mono from Ortofon

It features Nude Elliptical r/R 8/18µm stylus that is a good solution for playing mono microgroove vinyl records. The Quintet Mono will track perfectly through even worn and damaged records and ensure the surface noise control.

Quintet Mono uses a strapped output to deliver the same output signal from both sets of pole pins. This effectively eliminates the need for mono-specific equipment, making it possible to enjoy true mono reproduction on any stereo playback system.

MC Quintet Mono is for playing mono microgroove vinyl records.

The ST-7 transformer will be a perfect match for the MC Quintet Mono cartridge.

LH-4000 headshell is specially recommended for MC Quintet cartridges series. 

MC Quintet Mono Technical data

Output voltage at 1 kHz 5 cm/sec - 0.3 mV

Frequency response 20 Hz - 20 kHz - +/-2.0 dB

Tracking ability at 315 Hz at recommended tracking force *) - 70 μm

Compliance, dynamic, lateral - 15 μm/mN

Stylus type - Nude Elliptical

Stylus tip radius - r/R 8/18 μm

Tracking force range - 2.1-2.5 g (21-25 mN)

Tracking force recommended - 2.3 g (23 mN)

Tracking angle - 20º

Internal impedance, DC resistance - 5 Ohm

Recommended load impedance - >20 Ohm

Cartridge body material - ABS/Aluminium

Coil wire material - Pure 4-nines silver/Ag

Cartridge colour - White

Cartridge weight - 9 g

*) Typical value

Compatibility with Rega brand TT/TA: 

REGA brand cartridges’ height from stylus tip to the top cartridge mounting surface is lower than standard. Therefore you would need spacers to ensure the correct set-up of the Ortofon cartridge.

Adjusting the height of your Rega tonearm is easy with Acoustic Signature's Spacer Set. It allows you to adjust the height from 0.5 mm to 3.5 mm in precise steps of 0.5 mm - without removing the tone arm. Simply loosen the screws, insert the AS-spacer, then lock the screws back down, and you're tonearm is ready to play.

2 - 3 mm spacers should be enough for Quintet cartridge.