Ortofon MC Quintet Bronze 唱頭

***本店商品網上及門市同步銷售，系統有機會未及時更新，將會有職員致電聯絡。***

***有現貨的商品1-3個工作天內會跟進及寄出。訂貨約需1-2個月。***

⬇️ MC Quintet 文件下載 ⬇️

用戶指南

產品資料

Features

The Quintet Bronze moves into the higher league of the Quintets.

The slim profile of its Nude Fine Line diamond stylus will track even the highest frequency information, making it a must for discerning listeners.

Additionally its larger footprint ensures reduced distortion and record wear.

The sound will be very evenhanded with respect to all aspects. Classical music will be reproduced with power and open space around each of the instruments.

The ST-7 transformer is a perfect match for the MC Quintet Bronze cartridge.

LH-4000 headshell is specially recommended for MC Quintet cartridges series. 

MC Quintet Bronze Technical data

Output voltage at 1000 Hz, 5cm/sec. - 0.3 mV

Channel balance at 1 kHz - < 1.2 dB

Channel separation at 1 kHz - > 23 dB

Channel separation at 15 kHz - > 15 dB

Frequency response 20-20.000 Hz - +/-1.5 dB

Tracking ability at 315Hz at recommended tracking force *) - 80 µm

Compliance, dynamic, lateral - 15 µm/mN

Stylus type - Nude Fine Line

Stylus tip radius - r/R 8/40 µm

Tracking force range - 2.1-2.5 g (21-25 mN)

Tracking force, recommended - 2.3 g (23 mN)

Tracking angle - 20°

Internal impedance, DC resistance - 5 Ohm

Recommended load impedance - > 20 Ohm

Cartridge body material - ABS/Aluminium

Coil wire material - Pure 4-nines copper

Cartridge colour - Bronze

Cartridge weight - 9 gram

*) Typical value

Compatibility with Rega brand TT/TA: 

REGA brand cartridges’ height from stylus tip to the top cartridge mounting surface is lower than standard. Therefore you would need spacers to ensure the correct set-up of the Ortofon cartridge.

Adjusting the height of your Rega tonearm is easy with Acoustic Signature's Spacer Set. It allows you to adjust the height from 0.5 mm to 3.5 mm in precise steps of 0.5 mm - without removing the tone arm. Simply loosen the screws, insert the AS-spacer, then lock the screws back down, and you're tonearm is ready to play.

3.2 - 4 mm spacers should be enough for Quintet cartridge.